These are available with mounts sized for multiple rail diameters, come with clamp inserts to get a perfect fit, are made from top-shelf 316-L stainless-steel, and can be rotated and locked in place in 18-degree increments. When it comes to rail-mounts, it’s going to be very difficult to find a better pick than the Taco Clamp-On. If they stick outboard of the boat’s rails they may snag on pilings, docks, or anything else the side of the boat comes up against, and in that case damage to both the rod holder and the rail is the common result. Be careful, however, about where and how you locate them. Plus, installation is incredibly easy because rail-mounts clamp right onto the existing structure. If your boat has rails there’s a strong possibility that rail-mount rod holders will be your best option, simply because the rails may interfere with other types of rod holders you may try to mount. And although they’re made from fiber-reinforced nylon as opposed to stainless-steel, these holders are quite beefy and can stand up to gobs of pressure. We also love that the removable bases for these can be either side- or top-mounted, and the angle you set them at is fully adjustable. We love the Scotty Orca because it allows you to pop the rod out in one smooth, hook-setting motion. And they certainly don’t look as slick as rod holders that are integrated with the boat. Since these rod holders stick up from the boat’s surface they can also create tripping points, or snags for your lines. Mounting with through-bolts is preferable to screws (since there’s less chance of them loosening over time), but in some cases you may not be able to access the back of the surface to put on the nuts. These aren’t usually as strong as some other types of rod holders, and if you go cheap you may end up with a rod holder that can’t stand up to the force applied by very large fish. The options are virtually endless and include all different price ranges. You can find surface mounts made of lightweight plastic, inexpensive metal, or heavy-duty stainless-steel. There are a zillion and one varieties to choose from, with all different sorts of screw, through-bolt, or track mounting systems. Surface-mount rod holders are great in that they can be place just about anywhere, on any sort of boat or surface from a kayak to a motor yacht. These don’t come cheap, though, and cost is approximately $130. We also like the slick-looking screwless mounting system, and the fact that it’s made out of rugged cast stainless-steel. The Gemlux Screwless Cup and Rod Holder is a primo flush-mount which is wide at the top and then narrows down to rod holder size, so it can do double-duty as both a cupholder and a rod holder. And on many boats the transom spots you might like to mount them are taken up by things like livewells or fishboxes. Not all boats have wide enough gunwales to accommodate them, and some don’t have enough open space below the surface you’d like to mount them on. But there are also a number of limitations on flush-mount holders, and some problems associated with them.įor starters, mounting is difficult and requires sawing a hole or holes in your boat. Leaning post and console vertical rocket launchersįlush-mount rod holders are a top pick for many anglers, for several reasons: they’re as sturdy as possible and can even take the pressure generated by huge offshore species like tunas and billfish they look slick sitting flush on a boat’s gunwales or transom and most have gimbal-pins in the bottom, for locking trolling rods in place.You say you’d like to add rod holders and rocket launchers to your fishing machine? No doubt you would - here are the types to consider, and some top picks: In fact, very few serious anglers feel that their boat has enough rod holders right out of the box. There’s one truism that holds across the spectrum of fishing boats, whether you cast from an aluminum fishing boat, a center console, or a bay boat: you can never have too many rod holders.
0 Comments
Leave a Reply. |